Week 10: Prototyping

Oct. 31 Small-Scale Bogie Team

The controls team and I talked about the selected  gimbal motor. Some concerns were raised about it not having a shaft and upon further investigation it was found that half of the motor enclosure would rotate not just the shaft. This will make mounting the motor difficult and we should look for alternatives. The need for a functioning test track and Bogie set up are hitting high demand and will most likely be the small scales topic for discussion among other things. As far as inductive charging the integration will be lead by the controls team with little Bogie involvement as it does not dorectly effect Bogie design. 

Comments

  1. Eric HagstromNovember 20, 2018 at 8:36 AM

    Thanks for the update Small Scale Bogie Team. Can you begin to assembly all of the individual parts you have completed in CAD, so I can get a good overview of what you have left to do?

    ReplyDelete

Post a Comment

Popular posts from this blog

Week 11: Small Scale Bogie

Image
NOV 7th - Small Scale Bogie Improvements Team Within this week I tested the use of flanged conical wheels to assess the feasibility of using them for passive turning on the track. The initial design was referenced to an existing design that had a slight angle to the wheel of about 3 degrees. Two wheels were attached to an axle and by gravity was allowed to roll down a curved track. The wheels unfortunately did not move as desired and rather continued in a straight line. A new set of wheels will be tested with a greater angle. The updated design is shown below which has a 25 degree angle. Updated Conical Wheels
Read more

Week 8: Lecture

OCT. 17th 2018--Small Scale Bogie Task Items: -Continue developing concepts -Create presentation Summary: For today we had about two hours to work on our project before meeting on campus for a lecture. Within the two hours I researched some more design concepts and looked up presentation requirements. The design concepts developed so far resemble that of a car frame allowing space between rails for placement of the drive components. Typical bogies utilize an H-frame design and will influence further design. The lecture discussed the effects of technology and social interaction. We conducted a survey and discussed in groups what we put down. A few groups presented in which most agreed that technology has had an effect on social interaction. 
Read more

Week 7: Rapid Prototyping

OCT. 10th 2018--Small Scale Bogie System Task Items: -Continue developing concepts -Obtain dimensions of components  Summary: This weeks class consisted of a quick meeting which eventually lead to everyone dispersing to their respective groups. While in groups I talked with the small-scale track team to overcome an issue with the track at the three-way junction. At the junction there was a large gap the bogie would surely fall through so it was decided to stagger the turns so one is behind the other.  Additionally, I spent time reading an article consisting of all the major modules for a bogie along with the different configurations. The article can be found below. The article helped map out possible concepts that I can build up on and replicate a more feasible design. To create functional parts, I will need to find the dimensions of all the components going on the bogie and create CAD model. After the models are created then I can build up the bogie. Article:...
Read more